Wellness Cocoon Fitness Pod Owner's Manual page 44

Preliminary Procedures:
1. Remove hood (See Section 7.1) and carefully set aside by placing edge of the hood on a
carpeted or padded floor as shown in 7.3.1 Upside down Hood Position.
2. Use wrenches for the pin bolt, washer and nylon spacer removal as shown in Figure 7.6.1
Removing Strut Pin Bolt and Nylon Spacers on Upper Hinge Assembly.
3. Remove five screws from the hinge plate attached to the base chassis as shown in Figure 7.6.2
Removing Hinge Plate Screws on Base Chassis.
4. Carefully lift the hinge assembly up and out of the base chassis and set on prepared work
surface.
Strut Removal Steps:
1. Use wrenches to remove pin bolt and nylon spacers from lower hinge area.
NOTE: Position of the spacers and washers for proper replacement.
2. Remove the struts.
Strut Replacement Steps:
1. Replacement struts are connected to the lower hinge mount by using pin bolt and nylon
spacers as shown in Figure 7.5.1 Lower End Hinge Location. Pin bolt should be firm, but not too
tight, to allow struts to pivot on bolt.
NOTE: It is important to note the struts should only be installed with the cylinder attached to
upper hinge mount and piston to lower hinge mount.
2. Reposition hinge assembly on base chassis. Affix to surface using the five screws and nuts
previously removed as shown in Figure 7.6.2 Removing Hinge Plate Screws on Base Chassis.
3. Struts are reconnected to the upper hinge mount by using the pin bolt, nylon spacers and
washer from removal procedure as shown in Figures 7.6.1 Removing Strut Pin Bolt and Nylon
Spacers on Upper Hinge Assembly and Figure 7.6.3 Pin Bolt Position on Hinge Assembly.
4. Re-assembly unit (See Section 7.2).
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.5.1 Lower End Hinge Location.
43