Table of Contents
Advertisement
Problem
Possible Cause
Noise
Uneven Surface
from
Vibration
Missing or mis-aligned balls
Loose motor
Motor cam hitting motor
Hood/base offset
No
Loose power connector.
Heat
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
•
•
•
guard
•
1. Raise hood
2. Slightly loosen black bolt in
3. Lower hood and center on
4. Slowly raise hood,
5. Tighten black bolt in hinge
Secure the heater connector to
the left of main hinge.
sure your connection is tight.
Screw down to point of
resistance, then make one last
quarter turn until you feel it
"click" and lock in place.
(NOTE: if it does not lock in
place it can cause internal
arching or failure of heater
operation).
Remedy
Move the unit to a level
padded or carpeted
surface.
Make sure all balls are in
place.
Tighten loose bolts on the
base of the motor assembly
clockwise with an
adjustable wrench.
Loosen and adjust guard to
eliminate cam contact.
Retighten guard.
•
Procedure:
center of main hinge plate
base
maintaining centering
plate
Make
Cross
Reference
Please refer
to Section II,
Inoperative
Heater
32
Advertisement
Table of Contents
