Wellness Cocoon Fitness Pod Owner's Manual page 40

2. Removal of hinge plate
Remove the five screws and nuts which attach the hinge plate to the hood as shown in 7.3.2
Removing Hinge Plate. Account for all five screws and nuts. Remove hinge plate and set aside.
CAUTION: Do not drop any parts into the heat duct or the heater.
3. Removal of heater air intake screen
On the side through which the heater harness cable protrudes, straighten black tabs on the
screen inside heater cavity, and remove screen as shown in Figure 7.3.3 Removing Heater
Intake Screens.
4. Removal of Heater Harness
Loosen strain relief bushing by turning plastic nut from the outside of the duct with a wrench
as shown in Figure 7.3.4 Removing Heater Harness. NOTE: It may be necessary to use a second
wrench to hold nut inside the heater cavity, as well. Grasp the harness and slide out of notch
in screen opening. Push harness and connector through the vacant screen opening and into
the heat duct. Next, pull the harness up through the hinge plate opening.
5. Removal of heater
Grasp heater brackets and pull heater assembly straight up toward you, tilting slightly to
prevent any damage to the wires, connectors or terminals which are located on either side of
heater as shown in Figure 7.3.5 Removing Heater.
5
Figure 7.3.2 Removing Hinge Plate.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
2
Center
Screw
3
4
Figure 7.3.3
Removing Heater Intake Screens.
39