Wellness Cocoon Fitness Pod Owner's Manual page 38

Tools Required: Adjustable or ½ inch wrench.
Hood Replacement:
1. With person on opposite sides of the hood, grasp the lower edge to lift as shown in Figure 7.1.3
Removing the Hood. To evenly distribute the weight of the hood, place hands approximately
15 - 20 inches from each end of the hood.
2. Carefully lift hood over base chassis and align hinge plate with hinge assembly as shown in
Figure 7.1.3 Removing the Hood.
3. Align hinge plate pins with slots on hinge assembly. Gently allow hood to slide down onto hinge
assembly until the hood pins are fully seated in slots as shown in Figure 7.2.1 Hood Alignment
of Pins and Hinge Assembly Hole in hinge assembly above struts should align with hole in hinge
plate. Insert black flange bolt, but do not tighten completely (95%).
4. Slowly lower the hood down to meet the base and verify proper alignment and seating of the
hood/base contact area.
5. Slowly raise hood to full open position, maintaining alignment. Tighten flange bolt.
6. Re-connect harnesses from hood to base as shown in Figure 7.1.1 Releasing Electrical
Connectors.
1. Align grooves/slots on each half of the electrical connector, so they fit together.
2. When electrical connector halves are seated, tighten threaded rings at bottom of
the connectors in a clockwise rotation until locked. Make sure your connection is
tight. Screw down to point of resistance, then make one last quarter turn until you
feel it "click" and lock in place. (NOTE: if it does not lock in place it can cause
internal arching or failure of heater operation).
Figure 7.2.1 Hood Alignment of Pins and Hinge Assembly.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com 37