Adjusting Counter-Balance Cylinders Struts - Wellness Cocoon Fitness Pod Owner's Manual

Figure 7.3.4 Removing Heater Harness.
Heater Replacement Steps:
1. Grasp the replacement heater by the heater brackets as shown in Figure 7.3.5 Removing
Heater.
2. Carefully lower the heater into the hood duct by tilting slightly to the side when inserting as
shown in Figure 7.3.5 Removing Heater. As heater is inserted into hood duct, use caution to
prevent pinched or chafed heater wires. Position insulating tape surrounding heater assembly
appropriately to cover the duct opening.
3. Pull harness and connector through screen opening. Reconnect strain relief bushing nut and
heater screen reversing Step 4 in Removing the Heater Assembly immediately above.
4. Replace the hinge plate and secure with five screws and nuts.
5. Re-attach heater assembly bracket to center holes of hinge plate using appropriate screws
and nuts.
6. Re-attach hood to base chassis (See Section 7.2).
7. Re-attach heater connection to base. Confirm proper alignment of connector holes and twist
lock in place.

7.4 Adjusting Counter-Balance Cylinders Struts

Precautions:
1. Turn OFF main power switch located underneath the bed and/or disconnect the Cocoon from
power source before beginning this procedure.
2. Two people are needed to perform portions of this procedure (hood removal and
attachment).
Tools Required: Two wrenches with ½ inch capability
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.3.5 Removing Heater.
40