Replacing The Hood Onto Base Chassis - Wellness Cocoon Fitness Pod Owner's Manual

Hood Removal Steps:
1. With a person on opposite sides, grasp the bottom edge of the hood to lift as shown in Figure
7.1.3 Removing the Hood. To evenly distribute the weight of the hood, place hands
approximately 15 - 20 inches from each end of the hood.
2. The hood should be gently lifted upward and forward until the hinge slide pins are free as
shown in Figure 7.2.1 Hood Alignment of Pins and Hinge Assembly. If the slide pins resist
movement, gently rock the hood side-to-side while lifting upward.
3. When slide pins are disengaged, carefully tilt hood forward and lift off the hinge. Move hood
to a safe area.
4. Carefully place edge of the hood on a carpeted or padded floor as shown in Figure 7.1.4 The
Hood. If service is to be performed inside the hood, place exterior shell curved side down on
a foam-cushioned surface.

7.2 Replacing the Hood onto Base Chassis

Precautions:
1. Disconnect from power source before beginning this procedure.
2. Two people are needed to perform this procedure.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.1.3 Removing the Hood.
Figure 7.1.4 The Hood.
36