Replacing Bed Assembly Onto Base Chassis - Wellness Cocoon Fitness Pod Owner's Manual

4. Carefully lift contour bed to disengage bed prop stand from brackets, lower bed prop stand
and continue to lift bed until it is free of the base chassis. The contour bed weighs
approximately 33 pounds or 15 kilograms. NOTE: It is suggested to have two people lift the
contour bed from the base chassis, as it may be awkward to handle alone.
7.8

Replacing Bed Assembly Onto Base Chassis

Precautions:
1. Turn OFF main power switch located on the control panel or disconnect the unit from power
source before beginning this procedure.
2. Two people may be needed to perform this procedure. Bed is not heavy (Approx. 60 lb./ 27
kg.) but it may be awkward to handle alone.
Bed Assembly Replacement Steps:
1. Raise hood until it reaches fully-open position.
2. Set six (6) bed support balls in recesses in base chassis.
3. Gently set contour bed onto the six (6) bed support balls (balls should fit into bed support cups
on underside of bed).
4. Raise the head area of the bed. Locate black bed prop stand. Raise bed to allow bed prop
stand to be raised up and inserted into brackets (near upper vibration motor) underneath bed
as shown in Figure 7.7.1 Bed Stand Bracket.
5. Lower contour bed onto bed prop stand as shown in Figure 7.7.2 Bed Assembly from Base
Chassis.
6. Plug electrical cords into electrical outlets in accordance with the label on the electrical box
cover as shown in Figure 7.7.3 Disconnect Electrical Cords from Power Box Cover while the
bed prop stand is holding the bed up.
7. Carefully lift head end of contoured bed to disengage prop stand. While continuing to hold the
head end of the bed up, remove bed prop stand from brackets and lower to base.
8. Slowly lower the contour bed back onto the six (6) bed support balls making sure the balls
remain in place for support.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Disconnect the
motors controller.
47