Removing Bed Assembly From Base Chassis - Wellness Cocoon Fitness Pod Owner's Manual

7.7 Removing Bed Assembly from Base Chassis

Precautions:
1. Turn OFF main power switch located on the control panel or disconnect the unit from power
source before beginning this procedure.
2. Two people may be needed to perform this procedure, as bed may be awkward to handle
alone.
Bed Assembly Removal Steps:
1. Raise hood to a fully opened position.
2. Raise shoulder end of the contour bed. Locate black bed prop stand in base of the Cocoon
under contour bed. Raise bed enough to allow bed prop stand to be lifted and inserted into
brackets attached to underside of contour bed, near upper vibration motor as shown in Figure
7.7.1 Bed Stand Bracket. Lower the bed onto bed prop stand as shown in Figure 7.7.2 Bed
Assembly from Base Chassis.
3. Disconnect the electrical cords from the two receptacles as shown in Figure 7.7.3 Disconnect
Electrical Cords from Power Box Cover.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.7.1 Bed Stand Bracket.
Figure 7.7.2 Bed Assembly from Base Chassis.
Bracket
46