4.6 Connecting the Power Cord
For safety, please check the operating
voltage before proceeding to install the
power. It must be identical with that of your
local power outlet. The voltage tag is
located on the vertical wall between the
bed and the pillow area.
Instructions for Connection of Power Cord as shown in Figure 4.7.1 Connection of Power Cord.
1. Locate the power cord in the component box and plug the square connector into the
base. Tighten the screw in the plug-retaining ring to hold plug firmly in place.
2. Plug the power cord into wall outlet.
3. Turn on the ON/OFF switch located on the control (face) panel to operate the unit.
3. Please refer to the TROUBLESHOOTING section if any problems arise.
4.7 Installing the Aroma Cup and Himalayan Salt Block
CAUTION: To be done when unit is turned off!!!
Install salt block as shown below. Next, hook the black metal cup holder/ring to the bottom of the
face fan grill as shown. NOTE: you may have to manually (and carefully) spread the hook bars
slightly to fit properly.
BETTER WELLNESS• BETTER LIFE| 1 800 445-8418 | www.wellness-usa.com
Figure 4.7.1 Connection of Power Cord.
14