Wellness Cocoon Fitness Pod Owner's Manual page 46

Figure 7.6.2 Removing Hinge Plate Screws on Base Chassis.
Hinge Replacement Steps:
(Keep Cylinder up, Piston down as shown in Figure 7.6.2 Removing Hinge Plate Screws on Base
Chassis)
1. Connect the struts to new lower hinge mount (See Section 7.5). NOTE: It is important to use the
same mounting hole as the previous hinge.
2. Position new hinge assembly on base chassis and affix to surface using the five screws and
nuts previously removed as shown in Figure 7.6.1 Removing Strut Pin Bolt and Nylon Spacers on
Upper Hinge Assembly.
3. Reconnect the struts to the upper hinge mount with the pin bolt, spacers and washer (See
Section 7.5). NOTE: It is important use the same mounting hole as the previous hinge.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
Figure 7.6.3 Pin Bolt Position on Hinge Assembly.
45