Chapter 7 Service; Removing The Hood - Wellness Cocoon Fitness Pod Owner's Manual

7.1 Removing the Hood

Precautions:
1. Disconnect the unit from the power source before beginning this procedure.
2. Two people are needed to perform this procedure.
Tools Required: Adjustable or ½ inch wrench
Preliminary procedures:
1. Release Electrical Connectors:
counterclockwise at the bottom of each of the electrical connectors, located on either side
of the main hinge/strut assembly. Next, pull the connectors up and away from fixed
receptacles of base chassis as shown in Figure 7.1.1 Releasing Electrical Connectors.
2. Removal of Flange Bolt: By using wrench at ½" setting, remove the center bolt from hood
hinge plate and set aside as shown in Figure 7.1.2 Removing Flange Bolt. Note: A spare flange
screw has been provided in the installation kit.
BE FIT• BE HEALTHY • BE WELL| 1 800 445-8418 | www.wellness-usa.com
CHAPTER 7 - SERVICE
Raise the hood fully. Rotate the threaded rings
Figure 7.1.1 Releasing Electrical Connectors.
Figure 7.1.2 Removing Flange Bolt.
35