Feeding (Pull-Off) Roller; Removing The; Removing The Main Cover - Canon DADF-Q1 Service Manual

Chapter 3
[1]
13) Remove the separation roller.
When mounting the one-way gear, be sure that the protrusion faces inside.
One-way gear

3.4.8 Feeding (pull-off) Roller

3.4.8.1 Removing the Front Cover
1) Remove the front cover [1].
-Three screws [2] (remove)
-One screw [3] (loosen)
F-3-168
3-24
[2]
F-3-165
Protrusion
F-3-166
F-3-167
F-3-169

3.4.8.2 Removing the Main Cover

1) Open the upper cover, and insert a screwdriver from above the hook; then,
remove the two hooks [1].
2) Free the hook of the pickup assembly cover [2] from the right stay; then,
detach it while paying attention to the hooks on the front and rear side
plates.
0011-8200
3) When you have removed the ADF controller cover, disconnect the con-
nector [3] of the ADF controller PCB; then, remove the screw [4], and re-
move the grounding wire [5]. Free the harness from the wire saddle [6],
and detach the other saddle [7].
[1]
[1]
F-3-170
[2]
Hooks
F-3-171
0011-8201