Reset Button; Using The Reset Button - ZyXEL Communications WX Series User Manual

• Repeater mode (modem/router to the WX Device)
1. Press the WPS button on the modem/router. Release it when the WPS LED blinks.
2. Press the WX Device WPS button just once for 1 to 3 seconds within 2 minutes to copy the WiFi
settings from your modem/router to the WX Device.
3. The Link LED lights up when the process is finished.
• Repeater mode (the WX Device to the WiFi client)
1. Press the WX Device WPS button just once for 1 to 3 seconds to copy the WiFi settings from the WX
Device to a WiFi client, such as your laptop.
2. Wait until the WPS LED blinks.
3. Press the WPS button on the client within 2 minutes.
• Repeater mode (Downlink Daisy Chain For MPro Mesh)
1. Press the first WX Device WPS button just once for 1 to 3 seconds.
2. Press the WPS button once on the downlink WX Device within 2 minutes.
Note: You must activate WPS in the WX Device and in another WiFi device within 2 minutes of
each other. Repeat this procedure separately for each WiFi client.
Note: With WPS, WiFi clients will only connect to the first WiFi network (SSID) in either a 2.4 GHz
or 5 GHz WiFi network.

2.5 RESET Button

If you forget your password or you cannot access the Web Configurator, you will need to use the RESET
button at the back of the WX Device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously saved, the password will be reset to the default key on
the device label.

2.5.1 Using the RESET Button

Make sure the power LED is on (not blinking).
1
Press the RESET button for longer than 5 seconds to set the WX Device back to its factory-default
2
configurations.
Chapter 2 Hardware
WX Series User's Guide
29