Figure 17 WX5610-B0 Rear Panel
The following table describes the WX Device panel ports and buttons.
Table 7 Panel Ports and Buttons
LABEL
LAN1/LAN2/1G LAN/2.5G
LAN
WPS
POWER ON/OFF or DC-IN
RESET
2.3 Wall Mounting
Do the following to attach your WX Device to a wall.
2.3.1 WX5600-T0 / WX3100-T0 Wall-Mounting
You may need screw anchors if mounting on a concrete or brick wall.
Chapter 2 Hardware
DESCRIPTION
Connect computers or other Ethernet devices to Ethernet ports for Internet access.
Press the WPS button once for 1 to 3 seconds to enable the AP/Repeater mode. (See
Section 2.4.1 on page 28
for more information)
Connect the power cable and then press the power button to start the device.
Press the button to return the WX Device to the factory defaults.
WX Series User's Guide
26