Table of Contents
Advertisement
• Repeater mode (modem/router to the WX Device)
1. Press the WPS button on the modem/router. Release it when the WPS LED blinks.
2. Press the WX Device
router to the WX Device.
3. The Link LED lights up when the process is finished.
• Repeater mode (the WX Device to the WiFi client)
1. Press the WX Device
Device to a WiFi client, such as your smartphone or laptop.
2. Wait until the WPS LED blinks.
3. Press the WPS button on the client within 2 minutes.
• Repeater mode (Downlink Daisy Chain For MPro Mesh)
1. Press the first WX Device
2. Press the
Note: You must activate WPS in the WX Device and in another wireless device within two
minutes of each other.
Note: With WPS, WiFi clients can only connect to the 5 GHz or 2.4 GHz WiFi network using the
first 5 GHz or 2.4 GHz SSID on the WX Device (in AP or repeater mode).
2.6 RESET Butto n
If you forget your password or you cannot access the Web Configurator, you will need to use the
button at the back of the WX Device to reload the factory-default configuration file. This means that you
will lose all configurations that you had previously saved, the password will be reset to the default key on
the device label.
2.6.1 Using the RESET Butto n
Make sure the power LED is on (not blinking).
1
Press the
2
RESET
configurations.
Chapter 2 Hardware
button once within 2 minutes to copy the WiFi settings from your modem/
WPS
button twice within 8 seconds to copy the WiFi settings from the WX
WPS
button twice within 8 seconds.
WPS
button once on the downlink WX Device within 2 minutes of each other.
WPS
button for longer than five seconds to set the WX Device back to its factory-default
WX Series User's Guide
29
RESET
Advertisement
Table of Contents
