When The Wx Device Is Not Connected To A Router/Modem - ZyXEL Communications WX Series User Manual

3.2.2 When the WX Device is not connected to a router/modem:

Make sure your WX Device hardware is properly connected (refer to the Quick Start Guide).
1
Give your computer a fixed IP address in the range between 192.168.1.3 and 192.168.1.254.
2
After you have set your computer's IP address, open a web browser such as Microsoft Edge and enter
3
"http://192.168.1.2" as the web address in your web browser.
Log into the Web Configurator.
4
A login screen displays. Select the language you prefer.
5
To access the administrative Web Configurator and manage the WX Device, enter the default user
6
name admin and the randomly assigned default password (see the device label) on the login screen
and click Login. If you have changed the password, enter your password and click Login.
Figure 21 Login Screen
Note: The default allowable times that you can enter the Password is 3. If you entered the
wrong password for the fourth time, by default the Web Configurator will lock itself for 5
minutes before you can try entering the correct Password again. You can change
these settings at Maintenance > User Account > Add New / Edit Account (see
13.2.1 on page
The following screen displays when you log into the Web Configurator for the first time. Enter a new
7
password, re-enter it to confirm, and click Change password. If you prefer to use the default password,
click Skip.
Chapter 3 Web Configurator
148).
WX Series User's Guide
31
Section