ZyXEL Communications WX Series User Manual page 49

The POWER and Link LED on the WX Device-2 turns steady green if the pairing process is successful. You
7
can also check the result on the app screen.
Click Done to finish the pairing process. The WX Device-1 (the controller) will undergo an automatic
8
configuration after a Mesh network is established. (See
Check the status of your WiFi Mesh network on the Home screen.
Successful pairing
The POWER LED shows if the WX Device-2 is ready to join the WiFi network. The LINK LED shows the WiFi link
9
quality. See Section Table 13 on page 49
Table 13 LED Table (for WX Device-2)
LED COLOR
POWER Green
Red
Link (with a Green
WiFi
Red
connection)
10 Now you can connect your WiFi clients to your WiFi Mesh network. To do this, note the SSID and WiFi key
printed on the side label of the WX Device-1 using this SSID.
Chapter 4 App Tutorials
for more information on LED behaviors.
STATUS DESCRIPTION
On Power is on or the MPro Mesh configuration process is done.
Blinking The WX Device-2 is starting up or under the MPro Mesh configuration process.
On The WX Device-2 detects a system error.
Blinking The WX Device-2 is upgrading firmware
On The WiFi connection to the WX Device-1 is good.
On The signal is too weak. Move the WX Device-2 closer to the WX Device-1.
WX Series User's Guide
49
Section 1.2 on page 15 for more information).