Table of Contents
Advertisement
®
Advanced Energy
Table F‑2. Converter box and analog box UPP commands (Continued)
Parameter
Switch contact
<AA>t1<VAL>
mode
For analog box with
multiple connections,
specify the analog out:
<AA>t1sX<VAL>
"1" is numeric.
Source for the
<AA>ss<VAL>
switch contact
For analog box with
multiple connections,
specify the analog out:
<AA>sssX<VAL>
Sensor head for
<AA>sx<VAL>
the switch
For analog box with
contact
multiple connections,
specify the analog out:
<AA>sxsX<VAL>
57010228-00C
Command
Valid values are 0 to 3.
The converter box will respond with the current
keys lock status.
Sets the mode for switch contact SP1 of the
converter box.
Valid values are 0 to 2.
Sets the temperature source for the switch
contact on the converter box.
Valid values are 0 and 1.
Sets the sensor head to be used for the switch
contact on the converter box. The set value
corresponds to either the assigned sensor head
address or the given sensor head number.
Valid values are A1 to A8 or N1 to N8.
UPP Commands
Impac
Description
0 = Keys are not locked
1 = Enable keys lock; you can disable keys
lock by setting the value to 0 or 2, or by
cycling power
2 = Disable keys lock
3 = Enable keys lock; you can disable keys
lock by setting the value to 2, but not by
cycling power
0 = Off
1 = Contact is switched (from open
to closed relay) when the temperature
is higher than the defined threshold
temperature
2 = Contact is switched (from open to
closed relay) when the temperature is lower
than the defined threshold temperature
0 = Temperature measured with the sensor
head
1 = Internal temperature of the sensor head
®
Series 600 Pyrometer
F‑7
Advertisement
Table of Contents
