Table of Contents
Advertisement
Pyrometer Parameters
(Converter Box with Display)
Table E‑1. Converter box parameters
Parameter
M/ADR
ADDR
ADDR/AUTO
M/UNIT
M/DISPL
OUT/MOD
OUT/REF
OUT/ERR
SP1/MOD
SP1/REF
SP1/ERR
SP1/TEMP
SP1/HYST
SP1/SRC
RS/INTERF
RS/BAUD
57010228-00C
Impac
Address (device address, 00 to 97)
Automatic addressing
• Reset all: Each sensor head will be set back to factory setting
(address 00)
• Address all: Each sensor head will be assigned a new
address (automatic addressing)
Activation or deactivation of automatic addressing (ON/OFF)
Temperature measuring unit (Celsius or Fahrenheit)
Orientation of the display
Analog output (4 mA to 20 mA, 0 mA to 20 mA, thermocouple
type J, thermocouple type K, or 0 V to 5 V
Select which sensor head will be relevant for the output signal
(indicated on the display with O on a green background)
Show or hide errors on the display (in case of an error or wrong
value at analog out)
Select when contact shall switch (OFF, BELOW, or OVER) the
selected switching temperature (the temperature display turns red
when the contact has switched and is active)
Select which sensor head will be relevant for the switching
contact (indicated on the display with S on a red background)
Show or hide errors on the display (in case of an error or wrong
value at switching contact)
Switching temperature
Hysteresis for switching point (2°C to 20°C)
Select the source temperature for switching point
• TEMP = Measuring temperature of sensor head
• TINT = Internal temperature of sensor head
Switch between RS-232 and RS-485
Baud rate: 4800 baud to 115200 baud
Pyrometer Parameters (Converter Box with Display)
®
Series 600 Pyrometer
Description
Appendix
E
E‑1
Advertisement
Table of Contents
