First Time Operation; Installing The Infra600 Software - Advanced Energy Impac 600 Series User Manual

Pyrometer

Table of Contents

Advanced Energy

Route two separate ground wires in the cable: one ground wire for the voltage

signals and one ground wire for the current signals. Both ground wires need to

be connected to the ground clamp of the multi-analog box.

On the PLC inputs side, either galvanically separate the voltage input module

and the current input module, or connect all of the signals to different inputs

on at least one of the modules. The differential inputs need to be > 100 kΩ for

sufficiently high resistance.

For more wiring details and examples, see

Multiple Analog

FIRST TIME OPERATION

First time operation depends on your application, pyrometer model, accessories, and

the communications being used.

To Operate the Pyrometer for the First Time

1. Install the Impac pyrometer according to the installation procedures in this user

manual.

Once connected to the power supply, the pyrometer is ready for immediate use.

When the pyrometer is powered on, if it has a display it shows the temperatures

measured by the sensor heads and the basic settings for the converter box

(digital output and analog output).

2. If applicable, install the Infra600 software.

3. If applicable, assign a unique address to the converter box.

4. If applicable, assign a unique address to each sensor head.

5. Verify that temperature measurements are being received from the pyrometer.

The Infra600 software is available as a free download with the Impac pyrometer.

You can download the Infra600 software from http://advancedenergy.com/infra600.

Locate the entry for Infra600 software, click Downloads, and download the

Infra600 .zip file.

57010228-00C

Outputs".

Installation, Setup, and Operation

Impac

Series 600 Pyrometer

Appendix H, "Wiring Diagrams for

3‑10

Table of Contents