Parameterizing Devices Using The Converter Box Display; Table 3-1. Soft Key Functions; Figure 3-5. Converter Box Display And Soft Keys - Advanced Energy Impac 600 Series User Manual

®
Advanced Energy
addition to the command name, the analog out, "sX", has to be added. X can range
from 1 to 8.
For example, to set analog output signal for analog out 1, the command would be:
<AA>ass1<VAL>.
The full list of UPP commands is in
PARAMETERIZING DEVICES USING THE CONVERTER BOX
DISPLAY
Use the four soft keys directly below the display to select a menu function located
directly above the key on the display. After an option is selected, the display
refreshes and shows options for the specific function. Specific tasks in this manual
refer to the soft key by the menu option displayed directly above the key.
PAR/ENT
Up arrow
Figure 3‑5. Converter box display and soft keys
Table 3‑1. Soft key functions
Soft Keys
PAR or ENT
Up arrow
57010228-00C
Appendix F, "UPP
Down arrow
DIS/ESC
• Initiates parameterization
• Selects desired device for parameterization
• Toggles between parameters after a device is selected
• Toggles devices for selection
• Increases a parameter value
Installation, Setup, and Operation
®
Impac Series 600 Pyrometer
Commands".
Connected sensor heads
Analog output
Switching contact
Measured temperatures
Converter box settings
Description
3‑15