Configuring Trays 3 And 4 Of The Tandem Tray Module - Xerox VersaLink B7025 User Manual

Configuring Trays 3 and 4 of the Tandem Tray Module

Trays 3 and 4 in the Tandem Tray Module are high-capacity paper trays. Configure Trays 3 and 4 to
support the paper in use.
If you are configuring the trays for the first time, configure them for the paper size that you need. If you
change the paper size, reconfigure the tray for the new paper size. For details on supported paper sizes,
refer to Supported Standard Paper Sizes
To configure Trays 3 and 4 in the Tandem Tray Module:
Note: Before you make any tray adjustments, compare the paper size to the current Tray 3 and 4
configurations. If the paper size matches the tray configuration, no tray adjustment is needed.
1. Remove any paper from the tray.
2. Pinch the guide lock on the front paper guide, then slide the paper guide to the required paper size.
3. To lock the paper guides into place, release the guide lock.
Note: The paper guides lock into place only at the designated standard paper sizes.
on page 146.
Xerox VersaLink B7025/B7030/B7035 Multifunction Printer
® ®
Paper and Media
149
User Guide