Floppy Drive Connector Installation - SOLTEK B9A-FGR Manual

2-7 Floppy Drive Connector Installation

To install FDC, you should connect the end of FDC cable with single
connector to the board, and connect the other end with two connectors
to the floppy drives.
C-Media
CMI 8768
1
JAUD1
VIA
VT6307S
SATA2
SATA1
NJ1
nVIDIA
nFORCE3
250 Gb
JBAT1
USB3
IDE2
USB4
1 1
J2
Fan3 IDE1
This kind of cable is dedicated for Mini-barebone
system because the ribbon can be bundled up and
will not block the air flow in the barebone cabinet.
A dedicated cable with 2nd connector for 2nd floppy
drive is an optional item in the Mini-barebone
System.
JKB1
CICADA
Fan2
Winbond
SimpliPHY
W83627HF
CIS8201
FD1
+12V Power
Fan1
Main Power
34-pin FDC cable
(Dedicated for Barebone)
Signal Swap End
To 1st Floppy Drive
Chapter 2 Hardware Setup
Floppy Drive Connector:
Orient the red line of the
Floppy Flat Cable to Pin1.
Pin 1 (to Red Line)
Red line
To mainboard
23