Preparation; Cabling; Network Environment; Placement Considerations - HMS Networks Anybus Wireless Bolt II User Manual

® ™
Anybus Wireless Bolt II

3. Preparation

3.1. Cabling

Have the following cables available:
• Ethernet cable for configuration
• Ethernet cable for connecting to network
NOTE
Both shielded and unshielded Ethernet cables may be used.
• Power cable or Power over Ethernet (PoE) power source.

3.2. Network Environment

Ensure that you have all the necessary information about the capabilities and restrictions of your local network
environment before installation.

3.3. Placement Considerations

For optimal reception, wireless devices require a zone between them clear of objects that could otherwise
obstruct or reflect the signal.
To avoid signal interference, a minimum distance of 50 cm between the wireless devices should be observed.
Figure 1. Required minimum distance between wireless devices

3.4. System Requirements

3.4.1. Supported Operating Systems

Operating System
Windows 7 SP1, 32-bit
Windows 7 SP1, 64-bit
Windows 10 64-bit
Windows 11 64-bit
Page 4 of 68
Description
Windows 7 32-bit with Service Pack 1
Windows 7 64-bit with Service Pack 1
Windows 10 64-bit
Windows 11 64-bit
Preparation
SCM-1202-209 Version 1.0