®
™
Anybus
Wireless Bolt II
Use Cases
7. Use Cases
7.1. Cable Replacement Between a PLC and a Network Switch
Figure 36. Cable replacement between a PLC and a Network Switch
About the Use Case
This use case describes how to set up Cable replacement between a Network Switch and a PLC using one Bolt II
access Point unit and one Bolt II Client unit.
An HMI and multiple I/O devices are connected to the Network Switch.
The HMI is connected to the Bolt II access point to access the PLC built-in web interface.
Page 40 of 68
SCM-1202-209 Version 1.0