Ethernet Settings; To Configure Ip Settings Manually - HMS Networks Anybus Wireless Bolt II User Manual

® ™
Anybus Wireless Bolt II

5.8. Ethernet Settings

5.8.1. To Configure IP Settings Manually

Figure 32. Ethernet IP Settings, DCHP client disabled
By default, DHCP client is disabled.
1. On the Ethernet page, ensure that the DHCP client enabled checkbox is deselected.
2. Configure the IP settings.
Setting
IP address
Subnet mask
Gateway address
Primary DNS
Secondary DNS
Page 34 of 68
Description
The Bolt II network IP address in IPv4 dot-decimal notation
The Bolt II network Subnet mask in IPv4 dot-decimal notation.
The Bolt II network Gateway address in IPv4 dot-decimal notation.
If there is no gateway available, set the Gateway address to: 0.0.0.0
The Bolt II network Primary DNS in IPv4 dot-decimal notation.
The Bolt II network Secondary DNS in IPv4 dot-decimal notation.
Ethernet Settings
SCM-1202-209 Version 1.0