®
™
Anybus
Wireless Bolt II
Access PLC from Handheld Device via Wi-Fi
7.2. Access PLC from Handheld Device via Wi-Fi
Figure 42. Access a PLC from a handheld device using WLAN
About the Use Case
This use case describes how to configure a Bolt II as a Wi-Fi access point.
A handheld device and a PLC connected to a wired network are connected to the Bolt II Wi-Fi access point.
The PLC built-in web interface can then be accessed via the handheld device.
Before You Begin
For information on how to configure the network settings, please refer to the documentation for the handheld
device and PLC.
Bolt II Configuration
Procedure
1. Log in to the Bolt II built-in web interface.
Figure 43. Bolt II Login
Page 44 of 68
SCM-1202-209 Version 1.0