Factory Reset Using The Reset Button - HMS Networks Anybus Wireless Bolt II User Manual

® ™
Anybus Wireless Bolt II

9.5. Factory Reset Using the Reset Button

Before You Begin
Factory reset will reset any on site made configuration changes and set the Bolt II to the same state as leaving
HMS production.
If the Firmware has been updated, factory reset will revert the Bolt II configuration to initial state after the
update.
During reset, the Bolt II is temporarily unavailable for approximately two minutes.
Procedure
1. Ensure that the Bolt II is powered on.
Figure 68. Power on the Bolt II
2. Use a pointed object, such as a paper clip to press and hold the Reset button for > 10 seconds.
Figure 69. Press and hold Reset button
3. Release the reset button and wait while the Bolt II reboots.
Result
When the Bolt II has successfully rebooted, the Bolt II configuration is reset to the factory default configuration
or the current configuration after firmware upgrade.
Page 64 of 68
Factory Reset Using the Reset Button
SCM-1202-209 Version 1.0