Reset Using The Built-In Web Interface - HMS Networks Anybus Wireless Bolt II User Manual

Reset Using the Built-In Web Interface

9.6. Reset Using the Built-In Web Interface
Before You Begin
Factory reset will reset any on site made configuration changes and set the Bolt II to the same state as leaving
HMS production.
If the Firmware has been updated, factory reset will revert the Bolt II configuration to initial state after the
update.
During reset, the Bolt II is temporarily unavailable for approximately two minutes.
Procedure
1. Ensure that the Bolt II is powered on and running.
Figure 70. Power on the Bolt II
2. Log in to the Bolt II built-in web interface.
SCM-1202-209 Version 1.0
® ™
Anybus Wireless Bolt II
Page 65 of 68