Access Point Settings - HMS Networks Anybus Wireless Bolt II User Manual

® ™
Anybus Wireless Bolt II

5.7.3. Access Point Settings

Ensure that Access point is selected on the Operation mode page.
On the Wireless page, configure the Access point settings for the Bolt II access point.
Figure 31. Access point page
Access Point Security Settings
Setting Value
Network name Default, Anybus_<dynamic>
(SSID)
<dynamic> is the last four digits of
the Bolt II MAC address. Example:
Anybus_a053
Radio frequency 2.4 Ghz, Default
band
5 Ghz
Broadcast the Broadcast the network name
network name (SSID) is enabled by default.
(SSID)
Channel Auto, Default
2.4 GHz channels: 1 to 11
5 GHz channels: 36, 40, 44, 48,
149, 153, 157, 161 and 165
Security type Open (Not recommended)
WPA2-Personal, Default
WPA3-Personal
Passphrase No default Passphrase is used.
Page 32 of 68
Description
Name the Bolt II access point with a unique SSID (Service Set IDentifier).
Select the radio frequency band to be used, 2.4 Ghz or 5 Ghz.
See also WLAN Channels and World Mode (page
By default, SSID broadcast is enabled. When users try to connect their wireless devices,
the name of the Bolt II access point appears in the list of available networks.
To disable SSID broadcast, deselect the Broadcast the network name (SSID) checkbox.
Select a Channel for the radio frequency band.
See also WLAN Channels and World Mode (page
Select a Security type for the wireless connection.
NOTE
For Cable Replacement Device A the Security type is locked to WPA2-
Personal.
Enter the Passphrase, password, for the selected Security type.
NOTE
The Passphrase must be a minimum of eight characters in length.
Wireless Settings
33).
33).
SCM-1202-209 Version 1.0