Wlan Channels And World Mode - HMS Networks Anybus Wireless Bolt II User Manual

Wireless Settings
Access Point IP Settings
By default, DHCP server is enabled. The Bolt II acts as a DHCP server and provides the IP settings to the client
devices connected to it.
IMPORTANT
By default, the Bolt II internal DHCP server is enabled. To avoid interference, keep only one DHCP
server enabled on the network.
To disable DHCP server, deselect the DHCP server enabled checkbox.
Setting
Start IP address
End IP address
Lease time
Lease interval
Subnet mask
Gateway address
Primary DNS
Secondary DNS

5.7.4. WLAN Channels and World Mode

WLAN Channels and World Mode is only used for Client Mode.
NOTE
The maximum output power will be reduced on some channels depending on regulatory
requirements.
Which channels are available for WLAN communication is restricted by the regulatory domain where the unit is
operating.
Bolt II supports regulatory domain detection and channel settings for FCC and ETSI according to the IEEE 802.11d
specification.
Table 4. Regulatory domains and WLAN channels
Domain
ETSI (European Telecommunications Standards Institute)
FCC (Federal Communications Commission)
SCM-1202-209 Version 1.0
Description
Enter the first IP address of the DHCP address pool.
Write in IPv4 dot-decimal notation.
Enter the last IP address of the DHCP address pool.
Write in IPv4 dot-decimal notation.
Set the length of time the clients can use an IP address assigned by the DHCP server.
Minimum: 5 minutes, 300 seconds
Maximum: 14 days, 1209600 seconds
Default: 24 hours, 86400 seconds
Set the length of time the DHCP server writes the lease information to the dhcp.leases file.
Minimum: 1 minutes, 60 seconds
Maximum: 2 hours, 7200 seconds
Default: 12 hours, 43200 seconds
The Bolt II network Subnet mask in IPv4 dot-decimal notation.
The Bolt II network Gateway address in IPv4 dot-decimal notation.
If there is no gateway available, set the Gateway address to: 0.0.0.0
Enter the network Primary DNS for the DHCP address pool.
Write in IPv4 dot-decimal notation.
Enter the network Secondary DNS for the DHCP address pool.
Write in IPv4 dot-decimal notation.
2.4 GHz
1-11
Anybus
5 GHz
36, 40, 44, 48, 149, 153, 157, 161, 165
® ™
Wireless Bolt II
Page 33 of 68