JRC JMR-92 Series Field Service Manual page 621

4.3.5.3 Replacing the Trackball: CCK-1060
[Required Tools]
The tools shown in the following table are required for replacement work.
No. Name
1 Phillips screwdriver
2 Diagonal pliers
3 Cable-tie *1
*1 A number of cable-ties may be required.
Before conducting replacement work, turn OFF the circuit breaker for the power supply of the
display unit.
Do not lose the screws as they will be needed again.
To prevent damage to the Unit during the replacement work, cut off cable-ties that fasten the
cable of the unit beforehand.
Step 1 Remove the screws of the TOPU and take out.
Remove the screws (M4: 2 locations) inside the two screw covers at the bottom right and left of
the trackball, and take out the TOPU from the mounting frame. For details, please refer to the
"Replacing the TOPU: NCE-5605."
Chapter 4 Replacement procedure
Table Required Tools
Size
Size #2
－
－
4-400
Appearance