JRC JMR-92 Series Field Service Manual page 568

- Settings for Serial port on CCU
Serial port settings on CCU is placed on the upper side of [System
Configuration] - [Serial Port] dialog. Select serial sensor connected with CCU.
- Settings for Contact output on CCU
Contact output settings on CCU is placed on the upper side of [System
Configuration] - [Contact] dialog. Select contact output function assigned to
CCU.
- Settings for Data output
[System Configuration] - [Data Output] dialog is Equipment-specific setting
item. Select the output data.
- Settings for Alert
[Setting] - [Alert] dialog is Equipment-specific setting item. When the system
assigned watch alarm to CCU and/or SLC, the items need to set up.
- Settings for AC Power Failure
[Setting] - [AC Power Failure] dialog is Equipment-specific setting item. Set up
to same as other display unit settings.
- Settings for VDR
[Setting] - [VDR] dialog is Equipment-specific setting item. When the systems
connected with the JRC – VDR, the items need to set up. Set up to Delay
Time that delays the timing of output each task station, e.g. 3 sec.
For more information, refer as follows.
- Installation information at the time of commissioning, which is described in
the installation check list
- Installation Manual 4.4 Subsystem Installation
- Installation Manual 4.6 Setting up a Serial Port
- Installation Manual 4.7 Setting Contacts (Contact Input/Output)
- Installation Manual 4.10 Setting Data Output
- Installation Manual 4.11 Network Setting
- Installation Manual 4.14 Setting Alert
- Installation Manual 4.15 Operation Setting at AC Power Failure (Insufficient
AC power supply)
- Installation Manual 4.17 Setting VDR
4-347 Chapter 4 Replacement procedure