JRC JMR-92 Series Field Service Manual page 584

14-6. Reconfigure the BAMS. (AMS Licence)
Set up the BAMS by referring the followings:
-
-
14-7. Setup for optional Licence.
To set up TCS optional Licence, refer the followings: (ECDIS)
-
-
-
To set up RADAR Overlay optional Licence, refer the followings: (ECDIS)
-
-
To set up Chart optional Licence, refer the followings: (RADAR)
-
-
-
Step 15 Check operation.
After reconfigure is completed, check the operation as follows.
(1) Start the MFD application. Check that there is no problem in its operation and processing.
(2) Conduct the operational inspection as described in "7.2 Operational Inspection" in Chapter
7, Troubleshooting.
This completes CCU replacement.
Installation information at the time of commissioning, which is described in
the installation check list
BAMS Instruction Manual
Installation information at the time of commissioning, which is described in
the installation check list
Installation Manual 4.12 Redundancy Setting
Installation Manual 4.18 Setting Autosail (Automatic Sailing System)
Installation information at the time of commissioning, which is described in
the installation check list
Installation Manual 4.4 Subsystem Installation
Installation information at the time of commissioning, which is described in
the installation check list
Additional Manual for Chart Installation 2.1 Importing ENC S-57/S-63
Charts, AVCS Charts and AIO Data
Additional Manual for Chart Installation 4.3 Importing C-MAP Ed.3
ARCS charts are not available in CHART RADAR.
4-363 Chapter 4 Replacement procedure