Table of Contents
Advertisement
Autopilot Failure
Hardware Malfunction
Software Malfunction
Approach to Critical Point
Actual Course Change
Early Course Change
Course difference
Cross of Track
End of track
Back-up Navigator Call
Track Control Stopped
Low Speed
Crossing Safety Contour
Crossing Area Boundary
Crossing a Danger
CPA/TCPA
AZ
Lost Target
Target Capacity
Multi Alert Output
(*1) Scheduled to be installed under INS support
(*2) Refer to "4.8 CAM Configuration and Setting" in the Installation Manual.
6.7.6 Testing each contact output
1.
Select one of the tabs from SLC1(M) to SLC4(M), SLC1(S) to SLC4(S), and ALC1 to
ALC4.
2.
Select the [Contact Output] tab.
3.
Turn on the light by clicking on the [Test] button of one of Contact1 to Contact8.
4.
To stop test output, turn off the light by clicking on the [Test] button again.
6.7.7 Checking the status of each contact input
1.
Select one of the tabs from SLC1(M) to SLC4(M), SLC1(S) to SLC4(S), and ALC1 to
ALC4.
2.
Select the [Contact Input] tab.
3.
Confirm the display of the Diagnosis lamp.
Green lamp display
White lamp display
Chapter 6 Connection to External Navigation Equipment
Autopilot and communication failure warning (automatic sailing)
Hardware failure alert
System malfunction alarm
Approach to critical point warning
Reply notification alert
Early course change alert
Course difference (ship's heading departing from the course) warning
Cross track alarm
Final destination arrival alarm
Backup navigator call alarm
TCS stopped
Low speed warning
Crossing safety contour alarm
Crossing special area boundary warning
Warning for approaching to danger
CPA/TCPA alarm
Automatic acquisition/automatic activation warning
Target lost warning
Warning on targets reaching maximum, Warning of reaching 95% of
capacity
Select when outputting multiple alerts from one contact. When this
output is selected, the Multi-Alert Output group is displayed.
: On (Active) status
: Off (Normal) status
6-36
Hide quick links:
Advertisement
Table of Contents
