JRC JMR-92 Series Field Service Manual page 797

6.3 Connection with ECDIS
6.3.1 Checking the Installation Status
Please refer to Chapter 3 in the "JMR-92XX/72XX JAN-92XX/72XX Installation Manual" and
check the installation status with the ECDIS.
6.3.2 Connecting with the ECDIS
The video signal of the RADAR is output from the J836 of the CQD-2273 radar interface circuit.
The radar interface circuit is mounted in the NQE-1143 JB.
Connect the No.1 ECDIS to J836 EX_OUT (VD+, VD-, TRG+, TRG-, BP+, BP-, BZ+, BZ-).
Target tracking information is output via LAN. Connect the ECDIS to the NQA-2443 Sensor LAN
switch. When connecting an ECDIS of the JAN-901B/701B, JAN-901/901M/701 or JAN-2000
model to the JMR-9200/7200 Series RADAR, perform output settings of the IEC61162-1 TX
terminal of the serial LAN interface circuit (SLC) in the display unit of the RADAR, and then output
the target tracking information.
For the details, please refer to Chapter 3 in the "JMR-92XX/72XX JAN-92XX/72XX Installation
Manual"
Chapter 6 Connection to External Navigation Equipment 6-12