JRC JMR-92 Series Field Service Manual page 754

5.3.2 Executing the SSD Recovery Tool
Execute the SSD recovery tool to write back the C drive image.
1.
Click on the [Disk Recovery] button in the dialog box that appears after starting from the
D drive.
The following dialog box appears.
2.
Select the image file you want to write back to the C drive.
Normally, select the image file that is displayed in the dialog box.
To specify another image file, click on the [Change File] button and then select the desired
image file from the file list that appears.
Note
Because the equipment has been started from the D drive, the regular C drive is displayed
as the D drive and the regular D drive is displayed as the C drive. So please be careful with
this when selecting an image file.
3.
Click on the [OK] button.
Image file write back starts.
Caution
Do not perform any other operations until write back finishes. Doing other operations may
cause image write back to fail.
When write back is completed, the following message is displayed.
5-11 Section 5 Software Update