JRC JMR-92 Series Field Service Manual page 809

[When the sensor is "Alert(to CAM)"]
[When the sensor is " Alert(to BNWAS)"]
[When the sensor is "DSC", or "- (not selected)"]
No display
2. Perform the settings shown in the following table and then click on the
[Set] button.
Setting Item
Baud Rate
[Baud Rate] addition
ratio combo box
Data Length
Chapter 6 Connection to External Navigation Equipment
Description of Setting
Select the baud rate of the corresponding serial
port from the combo box.
In the [Detail] dialog of CH8 to CH10, the [Baud
Rate] addition ratio combo box is displayed on
the right side of the [Baud Rate] combo box.
The combo box is displayed in the [Detail]
*1
dialog of AIS, GYRO
The addition ratio (%) for adjusting the baud
rate can be changed in the combo box. The
baud rate that is used for communication is
the value obtained by adding the addition
ratio set here to the value that is set in the
[Baud Rate] combo box.
Example) 4800 × (1 + 1.5/100) = 4872
Addition ratio
<Adjustment method>
At first, use 1.5% as the addition ratio. If
data cannot be received, decrease it in
decrements of 0.5%.
(*1) Only when selection of a sensor is other
than "Heading Sensor 1/2(Gyro I/F)".
Select the data length of the corresponding serial
port from the combo box.
6-24
Selectable
vary depending on the
serial port (refer to "Table
4-4
rates").
0.0% to 3.0% (Can be set
, and CH8 to CH10. in the unit of 0.5%)
5/6/7/8
Setting Value
baud rates
Selectable baud