Personalizing The Flexset; Placing The Telephone Number; Programming The Buttons; Handset Hook - Tadiran Telecom FlexSet 280 Manual

5
Figure 1-6 FlexSet
Handset Hook &
Telephone Number

Personalizing the FlexSet

Placing the Telephone Number

1. Use a pointed object such as a paper clip to remove the clear plastic covering over
the blank telephone number. See Figure 1-6.
2. Write/type the telephone number of the keyset on the blank label and replace it
Or
Print the telephone number using the DESI software (see Preparing the Blank Button
Labels on page 1-14)
3. Press the plastic cover back in place over the phone number.
Off-Hook
Removable Handset
Place Telephone
Number here
(plastic cover)

Programming the Buttons

The FlexSet series features 6 (FlexSet 120S, 121S), 8 (FlexSet 120, 120L, 120D),
22 (FlexSet 280S, 281S) or 24 (FlexSet 280, 280D, 280D-Z) user programmable buttons
and 4 additional buttons. These additional buttons are programmed system-wide by
the system administer for commonly used features. There is a light emitting diode
(LED) on each button to show the status of the station, trunk, or feature associated
with the button.
The programmable buttons may be assigned so that they directly access other stations,
station groups, trunks, trunk groups or system features. Buttons may also store several
dial commands in series. This is useful for one-button speed dialing, voice response,
voice mail, system access and other complex dialing patterns.
Handset
On-Hook
1-13
Coral Terminal Equipment