Appendix D: Software Change Log - Scanivalve DSA3217-PTP Series Operation And Service Manual

Appendix

Appendix D: Software Change Log

Version 1.00 - Initial Release (April 2018)
Verison 1.01 - Corrected a socket issue pertaining to data transfer. (August 2018)
Version 1.02 - Added limit settings under LIST LIMIT. LIST B now determines the actions of CALZ and CALB. (September
2018)
Version 1.03 - Fixed a bug involving CALZ command. (October 2018)
Version 1.04 - Improved high scan rate reliability. Corrected a bug when using Scan Start Time and Scan Start Date.
Changed PTP control to prevent clock from reinitializing when PTPEN is already enabled. (January 2019)
Version 1.05 - Increased receive buffer size. Altered scan start delay time. (March 2019)
Version 1.06 - Resolved an issue with time stamps in ASCII data output. Added DOUT command. (March 2020)
Version 1.07 - Altered the PERIOD setting in the FPGA to improve data rate consistency. (May 2020)
Version 1.08 - Resolved issue with PTP timestamp when TIME == 3. Changed PTP flag in transport packet. Changed
PERIOD variable to allow 4 decimal places. (March 2021)
Version 1.09 - Resolved issue when setting the scan rate. (June 2021)
Version 2.00 - Support new FPGA chip. This version requires new firmware (.HEX) and FPGA (.BIT) file, and is not backward
compatible with older firmware versions. It is compatible with all DSA-PTP hardware. (April 2022)
Version 2.01 - Resolved issue with PTP synchronization when the Grandmaster time was in the past compared to the
DSA-PTP's current time. Randomized PTP Sequence ID value in delay request packets. Resolved an intermittent interrupt
reentry issue in certain scan configurations. (June 2022)
78
78
DSA3200-PTP