Kontron COMe-bID7 User Manual page 78

Sub-Screen Second Level
Sub-screen
SIO Read only field
Configuration
AMI SIO Driver Version
Serial Port 0
Read Only field
WARNING: Disabling SIO Logical Devices may have unwanted side effects.
PROCEED WITH CAUTION.
Serial Port 1
www.kontron.com
Further Sub-Screens/Description
[COM0, COM1]
Terminal Type VT-UTF8 is the preferred terminal type for
out-of-band management. The next best
choice is VT100+ and then VT100. See above,
in Console Redirection Settings page, for
more Help with Terminal Type/Emulation.
[VT100, VT100+, VT-UTF8, ANSI]
Bits per second Selects serial port transmission speed. The
speed must be matched on the other side.
Long or noisy lines may require lower speeds.
[9600, 19200, 57600, 115200]
Flow Control Flow control can prevent data loss from
buffer overflow. When sending data, if the
receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. Once the
buffers are empty, a 'start' signal can be sent
to re-start the flow. Hardware flow control
uses two wires to send start/stop signals.
[None, Hardware RTS/CTS, Software
Xon/Xoff]
Use This Device Enables the user to change the device's
resource settings. New setting will be
reflected on this setup page after system
restart.
[Enabled, Disabled]
Logical Device Read only field
Settings
Current
Possible Allows the user to change the device's
resource settings. New settings are
reflected on the Setup page after system
restarts.
[Use Automatic Settings]
Use This Device Enables the user to change the device's
resource settings. New setting will be
reflected on this setup page after system
restart.
[Enabled, Disabled]
Read only field
Logical Device
Settings
Current
Possible Allows the user to change the device's
resource settings. New settings are
reflected on the Setup page after system
restarts.
COMe-bID7 User Guide Rev. 1.2
// 78