Kontron COMe-bID7 User Manual page 73

Sub-Screen Second Level
Sub-screen
Reset Button
Behavior
I2C Speed
Onboard I2C
Mode
Manufacturing
Mode
BIOS Test Mode
ACPI
temperature
polling
TZ00
temperature
polling time
Create ACPI AC
adaptor
SMBus device
ACPI mode
CPLD device
ACPI mode
SPI lines active
Control COMe
GPIOs in BIOS
GPIO IRQ #
I2C IRQ #
Local FW Update
H/W Monitor CPU Temperature, Module Temperature
CPU
Temperature
CPU Fan –
Fan Control
CPU Fan –
Fan Pulse
www.kontron.com
Further Sub-Screens/Description
Global Lock
If set to Enabled, all Watchdog registers
(except for WD_KICK) to read only until board
is reset.
[Enabled, Disabled]
Stage 1 Mode Selects action for this Watchdog stage
[Disabled, Reset, Delay, WDT Signal only]
Selects reset button behavior
[Chipset Reset, Power Cycle]
Selects internal I2C bus speed between (1 kHz and 400 kHz) For
a default system 200kHz is appropriate.
[MultiMaster, BusClear]
Read only field
[Enabled]
[Disabled]
[Enabled, Disabled
30
[Enabled, Disabled]
[Normal, Hidden]
[Normal, Hidden]
[SPIO, GSPIO]
[Enabled, Disabled]
[Enabled, Disabled]
[Enabled, Disabled]
[Enabled, Disabled]
Read only field
Displays CPU temperature in °C
Set fan control mode.
'Disable' will totally stop the fan.
 Disable - stops fan.
 Manual – manually sets the fan.
 Auto – Hardware monitor controls cooling,
similar to ACPI based 'Active Cooling', without
producing a software load to the system.
[Disable, Manual, Auto]
Displays number of pulses fan produces during 1 revolution.
(Range: 1-4) [2]
COMe-bID7 User Guide Rev. 1.2
// 73