Getting Ready; Kit Contents; Additional Hardware; Windows Pc Workstation - NXP Semiconductors KITPF5030SKTEVM User Manual

NXP Semiconductors

3 Getting ready

Working with the KITPF5030SKTEVM requires the kit contents, additional hardware, and a Windows PC
workstation with installed software.

3.1 Kit contents

• Assembled and tested KITPF5030SKTEVM connected to a FRDM-KL25Z in an anti-static bag
• 2 ft or 3 ft USB-STD A to USB-B-mini cable
• 1x Pluggable terminal block, two positions, straight, 3.81 mm pitch
• 3x Pluggable terminal block, three positions, straight, 3.81 mm pitch
• Jumpers mounted on board
• Quick Start Guide

3.2 Additional hardware

In addition to the kit contents, the following hardware is necessary or beneficial when working with this kit.
• One or two power supplies with a range from 3.3 V to 5.0 V, and a current limit set initially to 1.0 A

3.3 Windows PC workstation

This evaluation board requires a Windows PC workstation. Meeting these minimum specifications should
produce great results when working with this evaluation board.
• USB-enabled computer with Windows 7 or Windows 10

3.4 Software

Installing software is necessary to work with this evaluation board. All listed software is available on the
evaluation boards information page.
•
http://www.nxp.com/KITPF5030SKTEVM
• NXP GUI for automotive PMIC families
UM11854
User manual
- latest version
All information provided in this document is subject to legal disclaimers.
Rev. 1 — 9 March 2023
KITPF5030SKTEVM programming board
UM11854
© 2023 NXP B.V. All rights reserved.
6 / 56