Table of Contents
Advertisement
UM11854
NXP Semiconductors
KITPF5030SKTEVM programming board
Figure 36. Bitmap dialog
Writing an INIT_FS register automatically updates the corresponding NOT register.
6.6.3.2 INIT Safety tab
This tab allows the initialization phase (INIT_FS state) configuration, that must be done before the first good
watchdog refresh until the 2 seconds timeout limit.
In this tab, safety features can be configured, such as the safety output reaction when voltage monitoring fault
is detected, watchdog refresh counter, fault error counter, as shown in
Figure
37. The Analog Built-In Self-
Test 2 ABIST2 (used for voltage monitoring assigned to external regulator), the VMON1 Static Voltage Scaling,
counters limit, and other INIT_FS registers are also configurable from this tab. See the PF5030 data sheet for a
complete description of these registers.
UM11854
All information provided in this document is subject to legal disclaimers.
© 2023 NXP B.V. All rights reserved.
User manual
Rev. 1 — 9 March 2023
40 / 56
Advertisement
Table of Contents
