Table of Contents
Advertisement
UM11854
NXP Semiconductors
KITPF5030SKTEVM programming board
OTP mode activation implies in Debug mode activation.
2
Debug and OTP modes can be disabled with an I
C command.
2
Test mode can be enabled at any moment with an I
C command when the voltage is applied on DBG pin.
7.3 Configuring the hardware for start-up
Figure 46
presents a typical hardware configuration incorporating the development board, power supply and,
Windows PC workstation.
Figure 46. Typical initial configuration
To configure the hardware and workstation as illustrated in
Figure
46, complete the following procedure:
UM11854
All information provided in this document is subject to legal disclaimers.
© 2023 NXP B.V. All rights reserved.
User manual
Rev. 1 — 9 March 2023
48 / 56
Advertisement
Table of Contents
