Getting Ready; Kit Contents; Additional Hardware; Minimum System Requirements - NXP Semiconductors KITFS23LDOEVM User Manual

UM11879
NXP Semiconductors
KITFS23LDOEVM evaluation board

3 Getting ready

Working with the KITFS23LDOEVM requires the kit contents, additional hardware, and a Windows PC
workstation with installed software.

3.1 Kit contents

The KITFS23LDOEVM kit contains the following items:
• Assembled and tested evaluation board with preprogrammed S32K144 microcontroller in an anti-static bag
• 3.0 ft USB-STD A to USB-B-micro cable
• Six connectors, terminal block plug, two positions, straight, 3.81 mm
• Three connectors, terminal block plug, three positions, straight, 3.81 mm
• Jumpers mounted on board

3.2 Additional hardware

In addition to the kit contents, the following hardware is necessary or beneficial when working with this kit.
• One power supply with a range up to 40 V.

3.3 Minimum system requirements

This evaluation board requires a Windows PC workstation.
• USB-enabled computer with Windows 7 or Windows 10
• FTDI USB serial port driver (for FT230X Basic UART device)

3.4 Software

Installing software is necessary to work with the KITFS23LDOEVM evaluation board.
All listed software is available on the evaluation board's information page at https://www.nxp.com/
KITFS23LDOEVM.
• NXP GUI for automotive SBC family installation package - latest version
UM11879 All information provided in this document is subject to legal disclaimers. © 2023 NXP B.V. All rights reserved.
User manual Rev. 2 — 25 September 2023
6 / 73