Preconfigured Storage Pool (Volume) - Silicon Graphics NAS MIS Setup Manual

Table of Contents

Preconfigured Storage Pool (Volume)

007-5921-001

Tip: If your internet browser does not connect to the appliance, it is likely because the primary

networking interface is misconfigured. Recheck the procedures you executed in the previous two

subsections. You may be able to fix the configuration by logging in to the console and running the

following command:

nmc:/$ setup appliance init

The appliance is preconfigured with a storage pool or volume, tank0, that is optimized for your

hardware configuration. To view the volume status, log in to the system console and execute the

setup status command:

nmc: /$ setup tank0 status

Use the preconfigured volume to create folders for CIFS or NFS shares or zvols or virtual block

devices for SCSI targets. Refer to the SGI NAS User Guide for further details on managing the

appliance.

Modular InfiniteStorage (MIS) NAS GUI Startup

Table of Contents

Do you have a question about the NAS MIS and is the answer not in the manual?