Registering The Sgi Mis Nas Software; Figure 3-4 Mis Nas Registration Panel Example - Silicon Graphics NAS MIS Setup Manual

Registering the SGI MIS NAS Software

007-5921-001
Boot the SGI MIS NAS appliance. After the appliance boots up, review and accept the SGI MIS
NAS software license agreement.
You can display licensing information in NAS Management View (NMV) by selecting the 'About'
link or use the following NAS Management Console (NMC) command:
nmc:/$ show appliance license
This will indicate whether you are using the trial or commercial edition, and how many days are
left in the case of a trial edition.
After obtaining the commercial license, you can register in NMC using the command:
nmc:/$ setup appliance register
Alternately, you can click on the 'Register' link at the top of the page in NMV. In NMV a form
similar to the following will appear, where you can enter the new license key:
Figure 3-4
MIS NAS Registration Panel Example
SGI NAS licenses are based on raw disk drive capacity and log, cache and spare devices are
excluded from the calculation.
Follow the instructions on the appliance's NAS management console (NMC) screen to register the
appliance software.
Note: The screenshots in this document are examples and may show different configuration
information than what you see. Ensure you enter the product registration key exactly as it appears
in the email sent when you register.
Modular InfiniteStorage (MIS) NAS GUI Startup
39