Choosing Sgi Nas Web Gui Transport Protocols; Figure 3-7 Primary Network Interface Selection Screen Example - Silicon Graphics NAS MIS Setup Manual

3: MIS NAS Operation and GUI Startup

Choosing SGI NAS Web GUI Transport Protocols

42
After you have reconfigured the Primary Network Interface, you should see an "Enabling
message" on the screen similar to:
Enabling ae0 via DHCP...OK.
After choosing your primary IP settings, you need to select no to the reconfigure prompt at the
bottom of the interface screen, see Figure 3-7.
Figure 3-7
Primary Network Interface Selection Screen Example
After you have configured the primary network interface, you must choose a transport protocol
for the SGI MIS NAS WEB GUI (NMV). You can select either HTTP – fast and (plain text)
unsecured, or HTTPS – secured, but less responsive.
Figure 3-8 on page 43 shows an example screen with a WEB GUI port selected to 2000 (the
default).
The example screen also shows the primary networking interface and its (configured) settings. At
this point you should be able to ping the appliance from an external host.
007-5921-001