Warning Information; Graphical Symbols - MicroPower SC Series Manual

Disconnect the battery and power supply
•
before maintenance, servicing or dismantling.
Check that the power supply at the site of the
•
installation complies with the rated voltage
specified on the battery charger's data label.
• The battery charger may only be connected to
a power outlet with protective earth.
• Do not operate the charger if there is any
evidence of damage.
If the supply cord or plug is damaged:
•
The manufacturer, its service agent or
•
similary qualified person must carry out
any replacement of the cord / plug in order
to avoid a hazard.
• Appliances with specially prepared cords
must be replaced by a special cord or
assembly available from the manufacturer
or its service agent.
• Other appliances that have a supply cord
that cannot be replaced, should be
scrapped.
If a stationary appliance is not fitted with a
•
supply cord and a plug, or with other means
for disconnection from the supply mains,
disconnection must be incorporated in the
fixed wiring in accordance with the national
wiring rules.
WARNING, risk of electric shock.
High output voltage. Do not touch
uninsulated battery terminals, con-
nectors or other live electrical parts.
When installing or performing work on battery,
charger and battery terminals - do not risk short
circuits. A short circuit may cause personal injury
and permanently damage the battery. For all work
on battery chargers, batteries and BMS, suitable
insulated tools must be used.

Warning information

Hazardous situations and precautions are
presented in the text as follows.
WARNING
Indicates a potentially dangerous situation. Death
or serious injury may occur if appropriate precau-
tions are not taken.
CAUTION
Indicates a situation where damage or injury
could occur. If it is not avoided, minor injury
and/or damage to property may result.
NOTE
General information not connected to safety for
person or the product.

Graphical symbols

The following graphical attention symbols may
appear on the products and in the documentation.
Read the instructions. The manual
contains important safety and oper-
ating instructions.
Stop operation. Always stop the
charging by pressing the STOP
button before any disconnection.
WARNING, risk of electric shock.
High voltage inside. High output
voltage. Do not touch uninsulated
battery terminals, connectors or
other live electrical parts.
CAUTION, undesirable conse-
quences. The situation needs
operator awareness or action.
For indoor use only. The battery
charger is designed only for indoor
use unless the charger is at least
IPX4-rated.
Introduction
This document contains use and maintenance
instructions for the intended battery charger.
This document is of relevance for the one who
uses the battery charger for its purpose; charge
batteries. It includes connecting the charger to the
battery, handling the charging process, and
managing basic settings.
Target groups:
Installers
•
Operators
•
Maintenance personnel and technicians
•
ENGLISH
5